LED Drivers for Cabinet & Furniture Lighting — 26 models

Cabinet, wardrobe and display-case lighting demands thin, cool-running, flicker-free drivers: the cavity is narrow, heat cannot escape, and the light is close to the eye. The ultra-slim models here hide behind shelves, on top of carcases or inside aluminium profiles. This page lists 26 suitable models: H08, H09, H12, H13, H14, H17, H18, H21, H22, K03, K04, K06, K07, R01, R02, R03, R04, R05, R06, S01, S02, S03, S04, X01, X02, X03. Power coverage 6W–600W, output 24V / 12V / 48V, protection IP50 / IP20 / IP67, dimming DALI, 0-10V, Push dimming, PWM, DIP-switch dimming, Rotary knob dimming. Factory-direct from YFX in Shenzhen with a 3-year warranty and free samples.

How to choose for cabinet & furniture lighting

• Thickness decides whether it fitsUltra-slim models drop into 15–25 mm gaps behind a shelf or into a profile. Measure the available cavity before ordering.
• Low heat protects the boardCopper-wound transformers, true-rated output and vented housings keep temperature rise under control, so panels do not discolour and strips do not fade early.
• Flicker-free mattersCabinet light is seen up close and flicker causes eye strain. Choose models specified as flicker-free with soft start so switch-on is gentle.
• Size for the actual runCabinet runs are usually 1–3 m and modest in wattage; one 60–100 W driver often serves several carcases. Zone the wiring and take power from a central point.
• Works with sensors and door switchesDoor, PIR and hand-wave sensors can be wired into the input or the low-voltage run so the light comes on when the door opens.

Model comparison

Sizing tip: divide total luminaire wattage by 0.8 so the load stays at or below 80% of the driver rating; allow 20%–25% headroom where the installation runs for many hours. If you are unsure, send your luminaire data to +86 138 2356 2421 (call or WeChat) and our engineers will specify it free of charge.

All suitable models

• 
  H0836-350W · IP50
• 
  H09100-350W · IP50
• 
  H1260-400W · IP20
• 
  H13100-600W · IP20
• 
  H1460-400W · IP20
• 
  H1735-400W · IP20
• 
  H1860-300W · IP67
• 
  H2124-200W · IP50
• 
  H2260-250W · IP50
• 
  K0360-400W · IP20
• 
  K0460-400W · IP20
• 
  K0625-36W · IP20
• 
  K076-36W · IP20
• 
  R0140-120W · IP20
• 
  R0224-72W · IP20
• 
  R0340-100W · IP20
• 
  R0460-300W · IP20
• 
  R05100-300W · IP20
• 
  R0660-100W · IP20
• 
  S0160-400W · IP20
• 
  S0260-400W · IP20
• 
  S0360-400W · IP67
• 
  S0410-50W · IP67
• 
  X0160-400W · IP20
• 
  X0245-400W · IP20
• 
  X0324-72W · IP20

Cabinet & Furniture Lighting FAQ

• Where should I hide the driver?

  On top of the carcase or behind a shelf, with an access point for service. Avoid drawer-rail areas and sealed pockets with no ventilation.
• Will the heat damage the wood?

  Choose true-rated rather than overstated wattage and keep load at 80% or below; temperature rise stays acceptable. In a sealed cavity, derate one further step.
• Is an ultra-slim driver powerful enough?

  Ultra-slim refers to height, not wattage. Models here span tens to hundreds of watts; one driver can feed several cabinets, or you can zone by carcase.
• Can I use a sensor or door switch?

  Yes. Sensors are usually wired in series with the input or the low-voltage run for open-and-glow with delayed off. A soft-start driver avoids inrush stress on the strip.

Related series and other applications